1004 Routers - Cisco ASR 1013 Hardware Installation Manual

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
g) Remove the small Phillips screw holding the eUSB board in-place (see the following figure).
Figure 256: Cisco ASR1000-RP eUSB Device
1
h) Gently pull the eUSB device up from its connector and remove it.
i) Place the eUSB device in an antistatic bag for return.
What to Do Next
You have removed the Cisco ASR1000-RP and eUSB component.
Remove and Replace the eUSB Device on the Cisco ASR 1006 and Cisco ASR

1004 Routers

To replace the eUSB component, follow these steps:
Remove and Replace the eUSB Device on the Cisco ASR 1006 and Cisco ASR 1004 Routers
Cisco ASR 1000 Series RP eUSB device Phillips screw
Cisco ASR 1000 Series Router Hardware Installation Guide
521