Cisco ASR 1013 Hardware Installation Manual page 536

Removing and Replacing the Cisco ASR1000-RP2 DIMM Memory Modules
• Back up data that you want to save before replacing a eUSB device.
• Note that the component is keyed and slotted for easier connection.
• To ensure the DIMMs are functioning properly, all four DIMMs must be replaced at the same time and
must be of the same manufacturer and part number (since vendors may have multiple versions of the
DIMM).
The following table shows the slots that are supported for inserting memory DIMMs in Cisco ASR1000-RP2
Table 91: Cisco ASR1000-RP2 Supported Slots for Inserting Memory DIMMs
Memory PID Option
M-ASR1K-RP2-8GB=
M-ASR1K-RP2-16GB=
This section describes how to remove and then replace the Cisco ASR1000-RP2 module DIMMs (see the
following figure).
Figure 242: Cisco ASR1000-RP2 Module Internal Component Location
1
Cisco ASR 1000 Series Router Hardware Installation Guide
502
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Slot 0 Slot 1
2 GB module 2 GB module
4 GB Module 4 GB Module
Internal hard drive
location
Slot 2
2 GB module
4 GB Module
3 Cisco ASR1000-RP2
internal eUSB device
Slot 3
2 GB module
4 GB Module