Ac-Powered Routers - Cisco ASR 9000 Series Installation Manual

AC-Powered Routers

Caution
Proper grounding is necessary to avoid damage from lightning and power surges. See
Unit Bonding and Grounding Guidelines, on page 44
AC-Powered Routers
AC power modules operate in the input range of 180 VAC to 264 VAC, 47 to 63 Hz (nominal input level of
200 to 240 VAC). Refer the below tables for the minimum required AC service for version 1 and version 2
power modules.
Power redundancy requirements vary based on the system configuration (number and type of line cards, etc.).
AC-powered systems are 2N protected. A minimum of two power supplies are required for redundant operation.
Refer to the Cisco ASR 9000 Power Calculator at the following URL to determine actual redundancy
requirements for any given configuration:
Each of the AC power inputs requires a separate dedicated branch circuit. Note that the circuit breaker and
fuse lockout procedures should follow the rules and regulations in the National Electrical Code (NEC) and
any local codes. For a list of the nominal and acceptable value ranges for source AC power, see Cisco ASR
9000 Series Routers AC Electrical Specifications section of Cisco ASR 9000 Series Aggregation Services
Router Overview and Reference Guide.
This table lists the AC input power cord options, specifications, and Cisco product numbers for the AC input
version 1 power supply modules. lists the AC input power cord options, specifications, and Cisco product
numbers for the AC input version 2 power and version 3 supply modules.
Note Before connecting AC input power cords to the power system, make sure that the power cords are not energized.
Table 3: AC Input Power Cord Options for Version 1 Power System
Locale Part Number
Australia, New CAB-7513ACA=
Zealand
Australia, New CAB-AC-16A-AUS=
Zealand
China CAB-AC16A-CH=
Continental CAB-7513ACE=
Europe
CAB-2500W-EU=
CAB-AC-2500W-EU=
International CAB-AC-2500W-INT=
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
28
for grounding requirements.
http://tools.cisco.com/cpc/launch.jsp.
Length Plug Rating
14 ft (4.3 m) 15 A, 250
VAC
14 ft (4.3 m) 16A, 250 VAC
14 ft (4.3 m) 16 A, 250
VAC
14 ft (4.3 m) 16 A, 250
VAC
16 A, 250
VAC
16 A, 250
VAC
14 ft (4.3 m) 16 A, 250
VAC
Preparing for Installation
NEBS Supplemental
Power Cord Reference Illustration
Figure 26: AC Power Cord CAB-7513ACA=,
on page 30
Figure 27: AC Power Cord CAB-AC-16A-AUS,
on page 30
Figure 28: AC Power Cord CAB-AC16A-CH=,
on page 31
Figure 29: AC Power Cord CAB-7513ACE=, on
page 31
Figure 30: AC Power Cord CAB-2500W-EU=,
on page 31
Figure 31: AC Power Cord
CAB-AC-2500W-EU=, on page 32
Figure 32: AC Power Cord
CAB-AC-2500W-INT=, on page 32