Cisco ASR 1013 Hardware Installation Manual page 575

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
3
4
*For information about
the DB-25 alarm
connector, how it works,
and Cisco ASR 1000
series route processor
LEDs, see xref "How
Cisco ASR1000-RP
Alarm Monitoring
Works" section on page
2-20.
Note: Shielded cables
must be used to connect
to the DB-25 alarm
connector on both the AC
and DC power supplies,
in order to comply with
FCC/EN55022/CISPR22
Class A emissions
requirements.
The following figure shows the ASR1013/06-PWR-AC power supply of the Cisco ASR 1006 Router.
1
Removing and Replacing a AC Power Supply in Cisco ASR 1006 Router
Cable tie-wrap tabs 7
AC power supply captive 8
screws
AC power supply fan 6
Cisco ASR 1000 Series Router Hardware Installation Guide
AC power supply
Standby switch. A
Standby switch is not
considered a disconnect.
AC power supply LEDs
AC power inlet
541