Cisco ASR 1013 Hardware Installation Manual page 582

Removing and Replacing a DC Power Supply in Cisco ASR 1006 Router
The following figure shows the DC power supply terminal block for the ASR1013/06-PWR-DC power supply of the
Cisco ASR 1006 Router.
Figure 268: Cisco ASR 1006 Router DC Power Supply (ASR1013/06-PWR-DC) Terminal Block and Plastic Cover
1
2
Step 5 Remove the slotted plastic cover from the terminal block (see xref figure).
a) Loosen and remove the single screw on the plastic cover. The plastic cover has slots that help to slide it out diagonally
from the terminal block.
b) Using a nut driver (7/16 size), unsrew the positive kepnut, positive cable, and the flat washer, in that order. The
terminal block houses two double-hole barrel lugs.
c) Follow Step 4b and remove the negative cable.
Cisco ASR 1000 Series Router Hardware Installation Guide
548
Negative lead
Positive lead
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
3
4
Protective sleeving around
the stud and cable
Ground stud and cable