Cisco ASR 1013 Hardware Installation Manual page 627

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
The following figure shows the DC power supply terminal block and plastic cover.
Figure 295: Cisco ASR 1013 Router DC Power Supply Terminal Block and Plastic Cover
1
2
3
Step 5 Remove the slotted plastic cover from the terminal block (see xref fig).
a) Loosen and remove the single screw on the plastic cover. The plastic cover has slots that help to slide it out diagonally
from the terminal block.
b) Using a nut driver (7/16 size), unsrew the positive kepnut, positive cable, and the flat washer, in that order. The
terminal block houses two double-hole barrel lugs.
Removing and Replacing a DC Power Supply in Cisco ASR 1013 Router
Negative terminal
Positive terminal
Terminal block plastic cover
Cisco ASR 1000 Series Router Hardware Installation Guide
4
5
—
Plastic cover slotted area
Terminal block plastic cover
single screw
—
593