Removing And Replacing A Dc Power Supply In Cisco Asr 1004 Router - Cisco ASR 1013 Hardware Installation Manual

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Removing and Replacing a DC Power Supply in Cisco ASR 1004 Router

This section provides information about removing and installing a DC power supply in the Cisco ASR 1004
Router.
Warning When you install the unit, the ground connection must always be made first and disconnected last. Statement
1046
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074
The following figure shows the DC power supply and components for the Cisco ASR 1004 Router.
Figure 275: Cisco ASR 1004 Router DC Power Supply
1
Removing and Replacing a DC Power Supply in Cisco ASR 1004 Router
DC power supply 5
terminal block and plastic
cover
Cisco ASR 1000 Series Router Hardware Installation Guide
DC power supply ground
symbol
559