Cisco Integrated Asr1000-Rp1 For Cisco Asr 1002 Router - Cisco ASR 1013 Hardware Installation Manual

Cisco ASR 1000 Series Routers Component Overview
• Cisco IOS punt packet forwarding
• Active/Standby Cisco ASR 1000 Series Route Processor 1 and Cisco ASR 1000 Series Embedded
• Code storage and download operational code to Cisco ASR 1000 Series Embedded Services Processor
• Bulk storage: by default, it comes with a 40 GB hard disk drive (HDD).
The HDD on ASR1000 products may have capacity in excess of that defined in the datasheet. However,
Note
during manufacturing, steps may be taken to reduce the capacity visible to the IOS, so that the visible size
matches to the size specified in the datasheet.
• 2 MB upgradeable BootROM, 1 GB Embedded USB memory (eUSB)
• Comes with 2 GB of DRAM as default and can be upgradeable to 4 GB DRAM (except for the Cisco
• Front panel support: Console, 10/100 Management port, two USB ports, CON port, and AUX port.The
• A console port can run up to 115.2 kbps with hardware flow control. One port is used as the CONSOLE

Cisco Integrated ASR1000-RP1 for Cisco ASR 1002 Router

The route processor for the Cisco ASR 1002 Router is integrated in the chassis and supports all the typical
customer management interfaces such as the Ethernet network management port and console and auxiliary
serial ports of the route processor for the Cisco ASR 1006 and ASR 1004 routers. It also has LED status
indicators, an RJ-45 plug for a BITS timing reference and one USB ports which can be used with smart cards
for secure key distribution or for image or configuration file updates.
Services Processor selection
and Cisco ASR 1000 Series SPA Interface (SIP)
ASR 1002 embedded route processor).
Cisco ASR 1000 Series Routers have one Gigabit Ethernet Management Ethernet interface on each
Route Processor. The purpose of this interface is to allow users to perform management tasks on the
router; it is basically an interface that should not and often cannot forward network traffic but can
otherwise access the router, often via Telnet and SSH, and perform most management tasks on the router.
The interface is most useful before a router has begun routing, or in troubleshooting scenarios when the
SPA interfaces are inactive. The following aspects of the Management Ethernet interface should be
noted:
◦ Each RP has a Management Ethernet interface, but only the active RP has an accessible Management
Ethernet interface (the standby RP can be accessed using the console port, however).
◦ IPv4, IPv6, and ARP are the only routed protocols supported for the interface.
◦ The interface provides a method of access to the router even if the SPA interfaces or the IOS
processes are down.
port for secure configuration and status display. The default BAUD rate for the CONSOLE port should
be set at 9600 BAUD. Both the console and auxiliary ports are asynchronous serial ports.
Cisco Integrated ASR1000-RP1 for Cisco ASR 1002 Router
Cisco ASR 1000 Series Router Hardware Installation Guide
43