Chapter 1 4 Removing And Replacing Frus From The Cisco Asr 1000 Series Routers - Cisco ASR 1013 Hardware Installation Manual

Removing and Replacing FRUs from the Cisco
ASR 1000 Series Routers
This chapter describes procedures for removing and replacing field-replaceable units (FRUs) from Cisco
ASR 1000 Series Routers:
• Removing and Replacing Cisco ASR 1000 Series Route Processors, page 474
• Removing and Replacing Cisco ASR 1000 Series Route Processor Internal Hard Drive, page 476
• Removing and Replacing the Hard Drive on the Cisco ASR 1002-X Router, page 487
• Removing and Replacing the Hard Drive on the Cisco ASR 1001 Router, page 491
• Removing and Replacing the Cisco ASR 1000 Series DIMM Memory Modules, page 494
• Removing and Replacing Cisco ASR 1000 Router eUSB Devices, page 519
• Removing and Replacing Cisco ASR 1000 Series Router 1 GB USB Flash Token Memory Stick, page
527
• Minimum Requirements of eUSB Devices Supported on Cisco ASR 1000 Series Routers, page 529
• Removing and Replacing Cisco ASR 1000 Series Embedded Service Processors, page 531
• Removing and Replacing Cisco ASR 1000 Series Router SPAs and SPA Interface Processors, page
533
• Removing and Replacing the Cisco ASR 1006 Router Power Supplies, page 538
• Removing and Replacing the Cisco ASR 1004 Router Power Supplies, page 555
• Removing and Replacing the Cisco ASR 1002 Router Power Supplies, page 565
• Removing and Replacing the Cisco ASR 1013 Router Power Supplies, page 587
• Removing and Replacing the Cisco ASR 1001 Router Power Supplies, page 598
• Repacking the Router, page 612
C H A P T E R
Cisco ASR 1000 Series Router Hardware Installation Guide
14
473