Replacing The Ac Power Supply In Cisco Asr 1002 Router - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing an AC Power Supply in Cisco ASR 1002 Router

DETAILED STEPS

Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.

Tighten the captive screws.

Replacing the AC Power Supply in Cisco ASR 1002 Router

To connect AC power to the Cisco ASR 1002 Router, follow these steps:

SUMMARY STEPS

1. At the rear of the router, check that the power switch is in the Off (O) position.

2. Insert the AC power cable into the AC power inlet and then turn On (|).

3. To ensure that the AC power cord does not interfere with other cables or wires, dress the AC power cable

in one of the following ways.

4. Plug the AC power supply cable into the AC power source.

DETAILED STEPS

At the rear of the router, check that the power switch is in the Off (O) position.

Turn the power switch to the On (|) position after both power sides of the power cord are connected.

Insert the AC power cable into the AC power inlet and then turn On (|).

To ensure that the AC power cord does not interfere with other cables or wires, dress the AC power cable in one of the

following ways.

Cisco ASR 1000 Series Router Hardware Installation Guide

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Show Quick Links

Table of Contents