Cisco ASR 1013 Hardware Installation Manual page 645

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Step 9
Repeat Step 6 through Step 8 for the remaining two DC input power source wires, the positive lead wire and the negative
lead wire (see the following figure).
Figure 310: Inserting the DC Power Supply Terminal Block Plug in the Block Header
1
2
Secure the wires coming in from the terminal block plug so that they cannot be disturbed by casual contact.
Caution
Step 10 Use a tie wrap to secure the wires to the rack, so that the wires are not pulled from the terminal block plug by casual
contact. Make sure the tie wrap allows for some slack in the ground wire as shown in the following figure.
Figure 311: Complete DC Terminal Block Plug Insertion and Secure Tie Wrap
DC power supply negative
(-) lead wire
DC power supply positive
(+) lead wire
Cisco ASR 1000 Series Router Hardware Installation Guide
Removing DC Input Power from the Cisco ASR 1001 Router
3
—
DC power supply ground
lead wire
—
611