Connecting Power To The Cisco Asr 1006 Router - Cisco ASR 1013 Hardware Installation Manual

Cisco ASR 1006 Router Overview and Installation

Connecting Power to the Cisco ASR 1006 Router

The covers are an integral part of the safety design of the product. Do not operate the unit without the
Warning
covers installed. Statement 1077
When you install the unit, the ground connection must always be made first and disconnected last. Statement
Warning
1046
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
This section describes the procedure to connect AC input and DC input power to your Cisco ASR 1006 Router.
The DC power supply for the Cisco ASR 1006, ASR 1004, ASR 1002, and ASR 1013 routers operate at
individual specifications. The following table shows the common input ranges and circuit breaker requirements.
Table 48: Cisco ASR 1000 Series Router DC Power Supply System Input Requirements
Cisco ASR 1000 System Input Rating
Series Router DC (Amps)
Power Supply
Cisco ASR 1006 40
Cisco ASR 1004 24
Cisco ASR 1002 16
Cisco ASR 1013 40
Circuit Breaker AWG # Wire
Amps
Minimum Maximum
Always 50 Always AWG #6
wire
30 40
20 30
Always 50 Always AWG #6
wire
Cisco ASR 1000 Series Router Hardware Installation Guide

Connecting Power to the Cisco ASR 1006 Router

Minimum Maximum
10 8
12 10
165