Removing And Replacing A Dc Power Supply In Cisco Asr 1013 Router - Cisco ASR 1013 Hardware Installation Manual

Removing and Replacing a DC Power Supply in Cisco ASR 1013 Router

SUMMARY STEPS
1. Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.
2. Tighten the captive screws.
3. Insert the AC power cable.
4. Plug the power supply cable into the power source.
5. Turn the power supply Standby switch to the On (|) position.
DETAILED STEPS
Step 1 Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.
Step 2
Tighten the captive screws.
Step 3 Insert the AC power cable.
Step 4 Plug the power supply cable into the power source.
Step 5 Turn the power supply Standby switch to the On (|) position.
What to Do Next
This completes the procedure for installing the AC power supply in the Cisco ASR 1013 Router.
Removing and Replacing a DC Power Supply in Cisco ASR 1013 Router
This section provides information about removing and installing a DC power supply in the Cisco ASR 1013
Router.
Warning When you install the unit, the ground connection must always be made first and disconnected last. Statement
1046
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074
Cisco ASR 1000 Series Router Hardware Installation Guide
590
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers