Ac/Dc Power System Output For Cisco Asr 1013 - Cisco ASR 1013 Hardware Installation Manual

–48 VDC Power Supply LEDs and Connectors for Cisco ASR 1013
LED Label
OUTPUT FAIL

AC/DC Power System Output for Cisco ASR 1013

The power supply output tolerance is defined in the following table under all combinations of line variation.
Total system consumption per power supply should not exceed 1600 W.
The output tolerance values shown in this table apply to the ASR1013/06-PWR-DC and
Note
ASR1013/06-PWR-AC power supplies. The Cisco ASR 1013 Router and the Cisco ASR 1006 Router
support these power supplies.
Table 34: Cisco ASR 1013 Router Power System Output Voltage and Output Current
Output Voltage
Minimum
Nominal
Maximum
Output Current
Minimum
Maximum
Cisco ASR 1000 Series Router Hardware Installation Guide
82
LED
Power supply activity
+12 VDC
11.80 VDC
12.00 VDC
12.20 VDC
0 A
136 A
Cisco ASR 1000 Series Routers Component Overview
Color
Red
Description
When the LED is off, it signals
that the –48 VDC output
voltage are within the normal
operating range. Output voltage
between the minimum and
maximum limits will not create
an output fail alarm, and output
voltages below the minimum or
above the maximum will create
an Output Fail alarm.
When you turn the power
supply on, the red LED
illuminates for two to three
seconds to test LED operation
before going off.
+3.3 V
3.20 VDC
3.30 VDC
3.40 VDC
0 A
3.125 A