Attaching A Chassis Ground Connection - Cisco ASR 1013 Hardware Installation Manual

Attaching a Chassis Ground Connection

The following imave shows the locations at which to attach the front rack mount brackets to the Cisco ASR 1002-X
Router in a rack.
Figure 158: Chassis Rack Mount Bracket Ear Holes for the Cable Management Brackets
1
2
Step 3 Using the bottom rack mount ear hole, insert the screw through cable management bracket and into the chassis rack
mount (see Figure 158: Chassis Rack Mount Bracket Ear Holes for the Cable Management Brackets, on page
What to Do Next
This completes the procedure for installing the cable management brackets on the chassis.

Attaching a Chassis Ground Connection

Connecting the Cisco ASR 1002-X chassis to ground is required for all DC-powered installations and
AC-powered installation where compliance with Telcordia grounding requirements is necessary.
The dual-lug chassis ground stud must be installed and all the cards and filler plates must be fully inserted,
Caution
screwed in, and earthed to prevent a potential hazard in a telecom line.
Have the recommended tools and supplies available before you begin this procedure.
Cisco ASR 1000 Series Router Hardware Installation Guide
346
Secure the cable
management top screw and
bottom to this ear hole
Cable-management bracket
Cisco ASR 1002-X Router Overview and Installation
3 Front rack mount bracket
—
346).