Removing And Replacing The Cisco Asr 1004 Router Power Supplies - Cisco ASR 1000 Series Replacing

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
What to do next
Note The requirement for maximum torque applied to the power or ground Kepnuts must be 8 in-lb when the power
or ground lug is not present.
This completes the procedure for installing the DC power supply into the Cisco ASR 1006 Router.
Removing and Replacing the Cisco ASR 1004 Router Power
Supplies
The Cisco ASR 1004 Router contains power supplies that are field replaceable units. This section contains
the following topics:
Removing and Replacing an AC Power Supply in Cisco ASR 1004 Router
This section provides information about removing and replacing an AC power supply in the Cisco ASR 1004
Router.
Removing the AC Power Supply from Cisco ASR 1004 Router
Because of the power supply redundancy, there is no need to power off the Cisco ASR 1004 Router before
removing one of the AC power supplies.
The Cisco ASR 1004 Router has two of the same type power supplies in power supply Slot 0 and power
supply Slot 1. See the following figure.
Figure 48: Cisco ASR 1004 Router AC Power Supply Slot 0 and Slot 1
1

Removing and Replacing the Cisco ASR 1004 Router Power Supplies

AC power supply
Standby switch
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
4 AC power supply fan
71