Replacing A Shared Port Adapter In A Sip; Removing And Replacing The Cisco Asr 1006 Router Power Supplies; Removing And Replacing A Ac Power Supply In Cisco Asr 1006 Router; Removing The Ac Power Supply From Cisco Asr 1006 Router - Cisco ASR 1013 Hardware Installation Manual

Replacing a Shared Port Adapter in a SIP

What to Do Next
You have completed the removal procedure for the Cisco ASR 1000 Series SPA.
Replacing a Shared Port Adapter in a SIP
To replace a shared port adapter in a SIP module, follow these steps:
SUMMARY STEPS
1. To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at
the top left and top right of the SPA slot and are recessed about an inch.
2. Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface connector.
When fully seated, the SPA might be slightly behind the SIP faceplate.
3. After the SPA is properly seated, fasten the SPA in place with the captive installation screws on either
side of the SPA.
DETAILED STEPS
Step 1 To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at the top left and
top right of the SPA slot and are recessed about an inch.
Step 2 Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface connector. When fully
seated, the SPA might be slightly behind the SIP faceplate.
Step 3 After the SPA is properly seated, fasten the SPA in place with the captive installation screws on either side of the SPA.
Removing and Replacing the Cisco ASR 1006 Router Power
Supplies
The Cisco ASR 1006 Router contains power supplies that are field replaceable units. This section contains
the following topics:

Removing and Replacing a AC Power Supply in Cisco ASR 1006 Router

This section provides information about removing and replacing an AC power supply in the Cisco ASR 1006
Router.

Removing the AC Power Supply from Cisco ASR 1006 Router

Because of the power supply redundancy, there is no need to power off the Cisco ASR 1006 Router before
removing one of the AC power supplies.
Cisco ASR 1000 Series Router Hardware Installation Guide
538
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers