Removing The -48 Vdc Power Supply From Cisco Asr 1002 Router - Cisco ASR 1013 Hardware Installation Manual

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
The following figure shows the –48 VDC power supply and components for the Cisco ASR 1002 Router.
Figure 281: Cisco ASR 1002 Router – 48 VDC Power Supply
1
2
3
4
5
Removing the –48 VDC Power Supply from Cisco ASR 1002 Router
Before you can remove a –48 VDC power supply from the Cisco ASR 1002 Router, you must remove input
power going to the power supply.
Caution Make certain that the chassis ground is connected before you begin removing and installing the power
supply.
To remove the –48 VDC power supply from the Cisco ASR 1002 Router, follow this procedure:
Removing and Replacing a –48 VDC Power Supply in Cisco ASR 1002 Router
Power supply ESD socket 6
Power supply slot 0 label 7
Power supply switch 8
Standby/On (|)
Power supply LEDs 9
Fan 10
Cisco ASR 1000 Series Router Hardware Installation Guide
Power supply captive
installation screw
Power supply slot 1 label
Ground (GND)
Positive lead
Negative lead
571