Cautions And Regulatory Compliance Statements For Nebs - Cisco ASR 1013 Hardware Installation Manual

Cautions and Regulatory Compliance Statements for NEBS

Safety Compliance and NEBS Requirements
Telcordia NEBS GR-1089-Core Statement
The English warnings in this document are followed by a statement number. To see the translations of a
Note
warning into other languages, look up its statement number in
asr1000/rcsi/asr1rcsi.html
Services Router 1000 Series .

Cautions and Regulatory Compliance Statements for NEBS

The following table lists cautions, regulatory compliance statements, and requirements for the Network
Equipment-Building System (NEBS) certification from the Telcordia Electromagnetic Compatibility and
Electrical Safety – Generic Criteria for Network Telecommunications Equipment (A Module of LSSGR,
FR-64; TSGR, FR-440; and NEBSFR, FR-2063) Telcordia Technologies Generic Requirements,
GR-1089-CORE.
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, for
Caution
Ethernet RJ-45 ports, use only shielded Ethernet cables that are grounded on both ends. In a NEBS
installation, all Ethernet ports are limited to intrabuilding wiring.
The intrabuilding ports of the equipment or subassembly is only suitable for connection to intrabuilding
Caution
or unexposed wiring or cabling. The intrabuilding ports of the equipment or subassembly MUST NOT
be metallically connected to interfaces that connect to the OSP or its wiring. These interfaces are designed
for use only as intrabuilding interfaces (Type 2 or Type 4 ports as described in GR-1089-CORE), and
require isolation from the exposed OSP cabling. The addition of primary protectors is not sufficient
protection in order to connect these interfaces metallically to OSP wiring.
Products that have an AC power connection are intended for deployments where an external surge protective
device (SPD) is used at the AC power service equipment as defined by the National Electric Code (NEC).
This product is designed for a common bonding network (CBN) installation.
Cisco ASR 1000 Series Router Hardware Installation Guide
114
Regulatory, Compliance, and Safety Information for the Cisco Aggregation
Preparing Your Site for Installation
To comply with the Telcordia GR-1089
Caution
NEBS standard for electromagnetic
compatibility and safety, for Ethernet
RJ-45 ports, use only shielded Ethernet
cables that are grounded on both ends. In
a NEBS installation, all Ethernet ports are
limited to intrabuilding wiring.
GR-1089
GR-63
http://www.cisco.com/en/US/docs/routers/