Sd Card Slot Access For Bracket-Mounted Routers - Cisco CGR 1240 Mounting Instructions

4. Align the center hole of the mounting bracket over the previously installed bolt so that the bracket rests on the bolt.
Figure 43 Securing the Wall-mount Bracket to the Wall
3
Item Description
1 Bracket: bolt holes (4)
2 Customer-supplied hardware: 5/16th-in. or M8 bolts or equivalent (1)
3 Mounting bracket (1)
4 Center mounting hole (1)
5 Customer-supplied hardware: 5/16th-in. or M8 bolds or equivalent (4) (same as #2 above)
5. Install the four mounting bolts through the bracket and into the wall.
Secure properly by hand-tightening in a star pattern order, beginning with the first bolt, tighten using the wrench.
Torque based on hardware and wall material. Torque center bolt last.
6. Install the router onto the mounting bracket. See
7. Install the optional security panel. See

SD Card Slot Access for Bracket-Mounted Routers

When the Cisco mounting bracket is attached the router according to the instructions in this section, the bracket blocks
access to the SD card port slot the router exterior.
Note: You must open or remove the mounting bracket security panel to see or access the SD card port.
1
2
5
Install the Router onto the Mounting Bracket, page
Install the Optional Security Panel, page
68
62.
63.
4