Removing The Clutch - APRILIA SCARABEO 125 Service Manual

SCARABEO 125 - 200

Removing the clutch

Fit the special driven pulley spring compressor
tool:
•
Fit the driven pulley assembly on the
tool by inserting the three pins in the
ventilation holes in the ground holder
support.
•
Make sure that the clutch is perfectly
inserted into the adapter ring before
proceeding to tighten the clutch nut.
•
Use the special multipurpose wrench
to remove the nut fixing the clutch.
•
Disassemble the driven pulley into its
components (Clutch and spring with
plastic fitting).
CAUTION
THE TOOL MUST BE FIRMLY FIXED IN THE VICE AND THE
CENTRAL SCREW MUST TOUCH THE TOOL. EXCESSIVE
TORQUE MAY DEFORM THE SPECIFIC TOOL.
Specific tooling
AP8140259 Universal tool for clutch assem-
blies
AP8140665 Adapter for clutch assembly re-
moval
Pin retaining collar
- Remove the collar with the aid of 2 screwdrivers.
- Remove the 3 guide pins and the movable half-
pulley.
Engine
ENG - 71