Sony MVS-8000X User Manual page 417

4
Using any of the following methods, select the
register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
Knob Parameter Adjustment
1 Register Register number 1 to 99
2 Num Select number
of registers
• To select all registers, press [ALL].
5
In the <Attribute> group, press the buttons for the
attributes you want to apply, turning them on.
Carry out the following procedures for each of the
attributes.
For details of attributes and available attributes, see
"Snapshot Attributes" (page 412).
To apply the cross-point hold attributes
Notes
Applying the key disable attribute (so the key state is not
reflected) to cross-point hold requires a setting in setup.
For details, see "Snapshot Attributes" (page 412).
1
Press [XPT Hold].
The Snapshot >Attribute >Xpt Hold menu appears.
The status area shows a list of the currently selected
regions and bus names.
2
Using any of the following methods, select the
register.
• Press directly on the list in the status area. To select
one or more buses, press [Plural] and then select
buses.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
Knob Parameter Adjustment
a)
2 Destination Destination
selection
b)
3 Bus Bus name
selection
a) Appears when the region is RTR.
b) Appears when the region is other than RTR.
• To select all registers, press [ALL].
3
When the region is set to RTR (Router) only, press
[RTR Level].
A window appears for selecting the router level.
4
Press the level for which you want to set the cross-
point hold, turning it on, and press [OK]. To select all
levels, press [ALL].
Setting values
5
Press [On].
1 to 99
This enables cross-point hold on the selected bus or
buses.
To switch cross-point hold off, press [Off].
To apply the effect dissolve attribute
1
Press [Effect Dissolve], turning it on.
2
Turn the knob to set the effect dissolve duration.
Knob Parameter Adjustment
3
To set the duration for a dissolve set as a
temporary attribute effect
To set the duration for a dissolve set as a temporary
attribute effect in the numeric keypad control block, turn
the knob.
Knob Parameter Adjustment
5
To apply the auto transition attribute
Press [Auto Transition], turning it on.
To apply the GPI output attribute
1
Press [GPI Output], turning it on.
2
Turn the knob to set the port number.
Knob Parameter Adjustment
4
Setting values
1 to 128
To apply the clip event attribute
1 and upwards
Notes
The following operating procedure can be used only for
the frame memory channels assigned to a user region.
For details of frame memory assignment, see "Setting
User Regions" (page 526).
Eff Diss Dissolve duration 0 to 999
Duration
Temp Dur Temporary
attribute dissolve
duration
GPI Out GPI output port
Port number
Snapshot Operations in the Menus
Setting values
(frames)
Setting values
0 to 999 (frames)
Setting values
1 to 8
417