Resizer Interpolation Settings; Resizer Crop/Border Settings - Sony MVS-8000X User Manual

For details, see "Entering Three-Dimensional Parameter
Values" (page 237).
Resetting parameters
This operation is the same as DME three-dimensional
parameter resetting.
For details, see "Entering Three-Dimensional Parameter
Values" (page 237).
Clearing resizer effects
To clear two-dimensional transform and rotation
parameters only and set the initial state
In the device control block, press the [CLR WORK BUFR]
button in the operation buttons.
To clear all resizer parameters, and set the initial
state
In the device control block, press the [CLR WORK BUFR]
button in the operation buttons, twice in rapid succession.
For the initial state, you can select either the factory default
settings or user settings.
For details of how to make this selection, see "Selecting
the State After Powering On (Start Up Menu)" in Chapter
18 (Volume 2).

Resizer Interpolation Settings

For example, to make the interpolation settings for key 1
of the M/E-1 bank, use the following procedure.
1
In the M/E-1 >Key1 >Processed Key menu, press
[Resizer], turning it on.
2
Press [Resizer Process].
The Resizer Process menu appears.
3
In the <Video Field/Frame Mode> and other groups,
make the interpolation settings.
This operation is the same as when making the DME
interpolation settings for MVS-8000A.
For details, see Chapter 11 ""Interpolation Settings"
(page 297).
However, the following points are different from the
operation for MVE-8000A.
• [Interpolation Mode] can be set for any type of signal
formats.
• The anti-moire filter cannot be set.
118
Resizer

Resizer Crop/Border Settings

Making a crop setting for a key for which
resizer is on
For example, to make the crop settings for key 1 of the M/
E-1 bank, use the following procedure.
1
In the M/E-1 >Key1 >Processed Key menu, press
[Resizer], turning it on.
2
Press [Border/Crop].
The Border/Crop menu appears.
3
Press [Crop], turning it on.
4
Set the parameters.
These settings are the same as those for crop of DME.
For details, see "Crop Settings" (page 241).
Notes
If mosaic or defocus is enabled, and in the <Mosaic/
Defocus Mode> group you select Video/Key, then the crop
is disabled.
Applying a border to a key for which
resizer is on
For example, to add the border for key 1 of the M/E-1
bank, use the following procedure.
1
In the M/E-1 >Key1 >Processed Key menu, press
[Resizer], turning it on.
2
Press [Border/Crop].
The Border/Crop menu appears.
3
Press [Border], turning it on.
4
Set the parameters.
The valid ranges of the parameter values depend on the
combination of signal format (SD/HD) and aspect
ratio (4:3/16:9) selected in the system, as follows.
SD format
Knob Parameter Adjustment
1 H Simultaneously
adjust width of
left and right
borders
Setting values
0.00 to 4.00