Secondary Color Correction Operations; Luminance Processing Operations - Sony MVS-8000X User Manual

When turning [Position] on and setting the pattern
position
Knob Parameter Adjustment Setting values
1 Position H Horizontal
position
2 Position V Vertical
position
a) See "Setting the wipe position (Positioner)" (page 130).
When turning [Multi] on and replicating the same
pattern
Knob Parameter Adjustment
1 H Multi Number of
repetitions of
pattern
horizontally
2 V Multi Number of
repetitions of
pattern
vertically
3 Invert Type Replication
layout
a) See "Setting the wipe pattern replication (Multi)" (page 132).
When turning [Aspect] on and setting the aspect
ratio of the pattern
Knob Parameter Adjustment Setting values
1 Aspect aspect ratio –100.00 to +100.00
a) See "Setting the wipe pattern aspect ratio (Aspect ratio)" (page 132).
When turning the [Angle] on in the <Rotation>
group and slanting the pattern
Knob Parameter Adjustment Setting values
1 Angle Angle of
pattern
rotation
a) See "Angle" (page 131).
When turning [Speed] on in the <Rotation> group
and rotating the pattern at a fixed rate
Knob Parameter Adjustment Setting values
1 Speed Rotation
rate of
pattern
a) See "Speed" (page 131).
7
To invert the mask source, return to the Primary CCR
menu and press [Pri/Sec Mask Invrt], turning it on.
Notes
The mask function is common to the primary color
correction, secondary color correction, and spot color
a)
adjustment functions.
–200.00 to +200.00
a)
–200.00 to +200.00
Secondary Color Correction
Operations
For the six colors R (red), G (green), B (blue), Y (yellow),
C (cyan), and M (magenta), adjust the luminance and
saturation, and also the hue within a range of ±30 degrees
Setting values
of the center value for each color.
1 to 63
You can mask a part of the region to be corrected.
Applying secondary color correction
1 to 63
1
a)
1 to 4
2
3
4
a)
a)
–100.00 to +100.00
To return the parameter settings to their default
values
In the <Secondary CCR> group press [Unity].
Masking a part of the secondary color
correction
Set [Mask] to On in the Secondary CCR menu, then carry
out the same operation as described under "Masking a part
a)
–100.00 to +100.00
of the primary color correction" (page 196).

Luminance Processing Operations

After converting a signal to which RGB color correction
has been applied to a YUV signal, divide the luminance
levels into three regions, referred to as Dark, Middle, and
Bright, and apply video signal adjustments to these
regions.
In the CCR menu, press VF1 'CCR1' and HF3
'Secondary CCR.'
The Secondary CCR menu appears.
In the <Secondary CCR> group, press [Secondary
CCR], turning it on.
In the <Secondary CCR Adjust> group, select the
color for which you want to make the setting.
Adjust the following parameters.
Knob Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Delay Hue delay
Setting values
–100.00 to +100.00
0.00 to 200.00
–180.00 to +180.00
197
Color Corrector Functions