Sony MVS-8000X User Manual page 170

3
To set loop playback, press [Loop], turning it on.
4
To start playback, press [Play]. During playback, to
stop, press [Stop].
To cue up
Press [Cue].
To play the image at the beginning of the clip
(Clip Begin)
Press [Rewind].
To play the image at the end of the clip (Clip End)
Press [FF].
To specify the playback start point
To set the current position as the playback start point, in
the <Start TC> group, press [Set]. To set a different
position, press the [Start] status button, and enter a
timecode value from the numeric keypad window.
To specify the playback stop point
Start playback, and at the desired position press the
[STOP] button to stop playback, then in the <Stop TC>
group, press [Set]. To set to any position, press the [Stop]
status button, and enter a timecode value from the numeric
keypad window.
To change the current position
To change the current position, press the [Current] status
button, and enter a timecode value from the numeric
keypad window.
To delete the parts of a clip file other than the
playback part (trimming)
1
Set the playback start point and stop point.
2
Press [Trim].
A confirmation message appears.
3
Press [Yes].
Using the device control block (MKS-
8036A Search Dial Module, option) to play
back clips
Notes
A frame memory clip must first be recalled with a menu
operation.
1
With the device selection buttons, select the frame
memory clip to be played (FM1 CLIP to FM8 CLIP).
If the pair mode is on, both main and subsidiary FMs
light.
2
Press the [PLAY] button, turning it on.
170
Frame Memory Clip Operations
To stop playback, press [STOP] or any of the [SHTL],
[JOG], [CUE], [REW], [FF], and [ALL STOP]
buttons.
For details of the buttons in the device control block
(MKS-8036A search dial module, option), see "Device
Control Block (MKS-8036A Search Dial Module,
Option)" (page 46).
To specify the playback start point
To make the current position the playback start point, press
the [START TC] button. To set a different position, press
the [SET START TC] button, then enter the timecode from
the numeric keypad control block.
To specify the duration
Press the [SET DUR] button, and enter a timecode from
the numeric keypad control block. If the playback start
point is already set, this automatically sets the playback
stop point. If the playback stop point is already set, this
automatically sets the playback start point. (The duration
setting is not displayed in the device control block.)
To specify the playback stop point
Start playback, and at the desired position press the
[STOP] button to stop playback, then press the [STOP TC]
button. To set to any position, press the [SET STOP TC]
button, and enter a timecode from the numeric keypad
control block.
To carry out the variable speed playback
Use the search dial.
For details on using the search dial, see "Controlling the
Tape/Disk Transport" in Chapter 12 (Volume 2).
To apply a loop to a frame memory clip
Press the [LOOP] button.
Using the device control block (MKS-
8031TB trackball module, option) to play
back clips
Notes
A frame memory clip must first be recalled with a menu
operation.
1
Press the [DEV] button in the region selection buttons,
and select the frame memory clip for playback (FM1
CLIP to FM8 CLIP).
If the pair mode is on, both main and subsidiary FMs
light.
2
Press the [PLAY] button, turning it on.