Melt Settings - Sony MVS-8000X User Manual

To apply the Swirl effect
With the Swirl menu displayed, set the following
parameters.
Knob Parameter
1 Transition
2 Center
3 Outer
4 Area
To make the tip of the swirl stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
Knob Parameter Adjustment
1 Density
2 Random
To set the center position of the swirl
1
Press [Position], turning it on.
2
Set the following parameters.
Knob Parameter Adjustment Setting values
1 H
2 V
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9

Melt Settings

You can set the degree of transition, the degree of
extension in the image, the jaggedness of the melting
sections, and the amplitude, frequency, amount of
movement, and speed of the melting sections. You can also
set the slant of the borders, the shape of the sections that
begin to melt, and other parameters.
278
Applying Special Effects (Nonlinear Effect Settings)
Adjustment Setting values
Swirl amount 0.00 to 100.00
Amount of –8.000 to
rotation in +8.000
center of swirl
Amount of –8.000 to
rotation outside +8.000
of Area
Region of swirl 0.00 to 100.00
Setting values
Degree to 0.00 to 100.00
which image
disappears
Trail type and 0.00 to 100.00
amount of
stardust
Horizontal –8.000 to +8.000
center –32.000 to +32.000
position of
swirl
Vertical –6.000 to +6.000
center –18.000 to +18.000
position of
swirl
To apply the Melt effect
With the Melt menu displayed, use the following
procedure.
1
In the <Direction> group, select the direction in which
the image melts away.
Up: Melting occurs upward.
Down: Melting occurs downward.
2
To make transition settings, press [Transition] and set
the following parameters.
Knob Parameter Adjustment
1 Transition
2 Curve
3 Random
3
To make wave settings for melting part, press [Border]
and set the following parameters.
Knob Parameter Adjustment Setting values
1 Amp
2 Freq
a)
3 Offset
4 Speed
a)
b)
5 Slant
a)
b)
a) Set when Lock is on.
b) Set when Lock is off.
c) Setting for SD 4:3, SD 16:9
d) Setting for HD 4:3, HD 16:9
To stop the waves in the melting part
Press [Lock], turning it on.
With each press, the waves alternately stop and start
moving again.
To select the shape of the part beginning to melt
Press [Form] and set the following parameter.
Knob Parameter
1 Form
a) 1 (SINE): Sine wave
2 (PARABOLA): Parabola wave
3 (TRIANGLE): Triangular wave
4 (RECTANGLE): Rectangular wave
Setting values
Degree of 0.00 to 100.00
transition
Degree to 0.00 to 100.00
which image
stretches
Degree of 0.00 to 100.00
jaggies at
melted part
Amplitude of 0.00 to 100.00
waves
Frequency 0.00 to 100.00
of waves
Amount of –16.000 to +16.000
wave phase –64.000 to +64.000
offset
b)
Direction –100.00 to +100.00
and speed
of waves
Slant of –100.00 to +100.00
border
Adjustment Setting values
Waveform 1 to 8
c)
d)
a)