Other Key Setting Operations - Sony MVS-8000X User Manual

2
Using the DME channel selection buttons, select the
DME channel (DME1 to DME8) for applying the
effect.
The lit colors of the [DME1] to [DME8] buttons
indicate the DME assignment.
Lit green: Shows the DME assigned to the currently
selected key.
Lit amber: Shows the DME assigned to a key other
than the currently selected key.
Off: DME is not assigned.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME
channel.
The later selection is valid, and the button lights green.
You can check the DME operating status in the Status
menu (see page 189).
Selecting the video signal for the DME
assigned to a key
For the operating procedure, see"Selecting the video
signal for a DME assigned to a key" (page 108).
Assigning the DME output signal to a
monitor signal
1
Holding down the output destination specification
button [MON] in the key control block, use the DME
channel selection buttons to select the DME channel
(DME1 to DME8) you want to use.
The selected DME output is assigned to DME MON V
and DME MON K.
2
To check the DME assignment status, hold down just
the [MON] button.
While it is held down, the lit color of the [DME1] to
[DME8] buttons shows the key assignment status.
Lit green: Shows the DME currently being
monitored.
Lit amber: Shows a DME which can be monitored.
Off: DME is not assigned.

Other Key Setting Operations

Using an external processed key
You can select and use the key processed keyer key fill and
key source signals on the AUX buses.
1
Select the keyer to be allocated.
114
Key Adjustments (Key Control Block)
2
In the key control block, press [PROC KEY], turning
it on.
The button lights amber, and on the currently selected
keyer, the key fill and key source are assigned to
reentry signals PROC V and PROC K.
When a DME is selected on the currently selected
keyer, the key fill and key source signals to which the
DME effect is applied are assigned to PROC V and
PROC K.
Notes
You cannot select the PROC V and PROC K signals using
the cross-point selection buttons of the M/E or PGM/PST
bank.
Using a frame memory feed
When you press the [FM FEED] button in the key control
block, it lights momentarily amber, then the key fill and
key source signals processed in the currently selected
keyer are assigned to frame memory sources 1 and 2.
If a DME is selected on the currently selected keyer, then
the key fill and key source signals to which a DME effect
is applied are assigned to frame memory sources 1 and 2.
Carrying out a frame memory feed causes the [PROC
KEY] button to light amber.
Using the show key function
While the [SHOW KEY] button is held down, the key-
processed key source signal appears on the specified
output. (Show key mode)
Even when the [SHOW KEY] button is released, for a
preset time the show key mode is maintained. You can
specify the output to which the show key function is
applied and set the time for which the show key mode is
maintained after releasing the button in a Setup menu.
For details see "Settings for the Show Key Function" in
Chapter 20 (Volume 2).
Using the auto delegation function
To couple the selection in the key delegation buttons of the
independent key transition control block so that the key
control block delegation selection is automatically
switched, in the key control block press the [AUTO
DELEG] button, turning it on.
Returning the key adjustment values to
their defaults
Holding down a key type button ([LUM], [LIN], [CRK],
[CVK], or [PTN]) recalls the key default values (page 92).