Still Image Operations
The frame memory functions provides the following still
image file functions.
• Capturing and Saving an Input Image (page 161)
• Recalling Still Images (page 163)
• Image Output (page 164)
• Continuously Capturing Still Images (Record) (page
165)
• Recalling a Continuous Sequence of Still Images
(Animation) (page 165)
Notes
During playback of a frame memory clip of the pair
assigned to either of the target FM selection buttons (see
page 169), frame memory operations may not be
performed properly. Carry out frame memory operations
after stopping clip playback.
Interpreting the Frame Memory Menu
The menu screen consists of the following principal parts.
The frame memory selection area display is the same for
all except the Pattern Adjust/Pattern Select/Field Invert/
File (excluding Pair Recombination menu)/Folder/
External Device menus.
158
Still Image Operations
Preparations
Allocating the frame memory outputs (FM1
to FM8) to cross-point buttons
To output a frame memory image to a monitor, for
example, the output signal from the frame memory (FM1
to FM8) must be allocated to a cross-point button. Carry
out this allocation in the Setup menu.
Notes
When the signal format is 1080P, only the four options of
FM1 to FM4 can be used.
Accessing the Frame Memory menu
Most frame memory operations are carried out using the
Frame Memory menu.
To access the Frame Memory menu, use either of the
following procedures.
• In the menu control block, select the top menu selection
button [FRAME MEM].
• Press the cross-point button to which the frame memory
output is allocated twice in rapid succession.