The Bank selection here indicates the physical position
on the control panel, numbering from the top as the 1st
Row, 2nd Row, 3rd Row, and 4th Row.
On the MKS-9011 1M/E Control Panel only the 1st
Row is valid. On the MKS-9012 2M/E Control Panel,
only the 1st Row and 2nd Row are valid.
2
Select the bank that you want to assign to the selected
Bank number in the <M/E Assign> group.
The status area shows the interchanged state of the
banks.
Notes
• It is not possible to assign the same M/E logical bank
to more than one physical bank. Be sure to make
different M/E assignments.
• When the bank order is changed, the state of region
selection button assignment in the numeric keypad
control block also changes correspondingly.
3
For the selected Bank number, in the <M/E
Operation> group, select one of the following.
Enable: Enable panel display and operation of the
bank.
Disable: Enable only panel display, and disable
operation of the bank.
Inhibit: Disable both the panel display and operation
of the bank.
Notes
When this is set to Inhibit, snapshots of the bank are
not recalled.
Assigning Two M/E Banks to One M/
E Bank
1
In the Panel >Config menu, select the M/E bank for
which you want to make the setting.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1
Bank
a) Depends on the center control panel configuration. When 7 (Ext 3) is
selected, or a switcher bank is selected which is immediately above
a switcher bank to which nothing is assigned, then [Dual M/E
Assign] is invalid.
488
Overall Control Panel Settings (Config Menu)
Setting values
Selection of
a)
1 to 7
position of bank
for which you
want to make the
setting
For example, if the furthest bank from you is assigned
to M/E-1, and you want no shift button operation for
the bank, select 1 (1st Row) for Bank.
2
Press [Dual M/E Assign].
This assigns the furthest M/E bank from you to the
unshifted (shifted) cross-points and the M/E bank in
front of it to the shifted (unshifted) cross-points. For
fader lever operations, only the M/E bank closer to you
is enabled.
The shift/non-shift assignment is set by [Dual M/E Xpt
Swap].
For more details, see the next section, "Interchanging
shifted and non-shifted operations for a dual M/E."
To return to the original assignment
Interchange the bank order (see page 487).
Interchanging shifted and non-shifted
operations for a dual M/E
1
In the Panel >Config menu, select the M/E bank for
which the dual M/E setting is made.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1
Bank
Bank to be
selected for dual
M/E setting
2
Press [Dual M/E Xpt Swap], toggling it on or off.
On: The lower M/E bank is non-shifted, and the
higher M/E bank is shifted.
Off: The lower M/E bank is shifted, and the higher M/
E bank is non-shifted.
Assigning the Key Delegation in the
Downstream Key Control Block
(MKS-8032 DSK Fader Module,
Option)
As an example, to assign key 4 of the M/E-1 bank to key
delegation button 1 of the downstream key control block 1,
use the following procedure.
1
In the Panel >Config menu, press the [DSK Fader
Assign].
The DSK Fader Assign menu appears.
Setting values
1 to 7