Sony MVS-8000X User Manual page 512

a)
Command name
Pre Macro
Post Macro
Macro Take
Macro Auto Ins
Macro AT with Rate
Macro AT with A/B Bus
Macro TL with Region
DME Override
DME Graphic
Plug-In Editor Enbl
Inhibit Set
Inhibit All Clear
b)
K-SS Store
a) For the safe title on/off commands (from ME1 PGM1 ST-ME1 PGM4 ST
to AUX1 ST-AUX48 ST), the name of the assigned output signal is
shown.
b) Pressing this button to turn it on enables key snapshot operations for all
control blocks.
Assigning a menu shortcut to a memory
recall button
1
Referring to the procedure up to step 3 on "Assigning
a Function to a Memory Recall Button in the Utility/
Shotbox Control Block (MKS-8033 Utility/Shotbox
Module, Option)" (page 509), select [Menu Shortcut].
The memory recall buttons in the utility/shotbox
control block flash orange.
2
Using any of the following methods, display the menu
to which you want to make a shortcut.
• In the menu control block, press the relevant top
menu selection button, then select VF and HF.
• Press the menu page number button in the upper left
corner of the menu screen, then enter a menu number
from the numeric keypad window.
• Press a particular control panel button twice in rapid
succession.
512
Setting Button Assignments (Prefs/Utility Menu)
Function
Set macro attachment in pre macro mode
Set macro attachment in post macro mode
Macro execution
Macro auto insert mode on/off
When registering an auto transition macro
event, on/off setting of mode to save transition
rate
When registering an auto transition macro
event for the transition control block, on/off
setting of mode to save A/B Bus cross-point
settings
When registering a timeline macro event, on/
off setting of mode to save applicable region
DME override on/off
DME graphics on/off (Applies to graphics for
channel selected in device control block)
Enable/disable operation from an editing
keyboard
Inhibit cross-point button
Clear all cross-point button inhibit settings
Enable/disable key snapshot saving
Button status
Lit green
Can be set only while
pressed (lit)
Can be set only while
pressed (lit)
During execution
On
On
On
On
On
On
Enabled
Can be set only while
pressed (lit)
Can be set only while
pressed (lit)
Enabled
3
In the utility/shotbox control block, select the bank,
and press the button to which you want to assign the
shortcut.
The menu screen goes back to the Prefs/Utility
>Utility Module Assign menu, and the selection is
reflected in the status area.
The buttons in the utility/shotbox control block flash.
4
Repeat steps 2 and 3 as required, to assign all desired
menu shortcuts to the buttons in the utility/shotbox
control block.
To abandon the process of menu shortcut
assignment
In the Prefs/Utility >Utility Module Assign menu, press
[Menu Shortcut].
This exits the menu shortcut assignment mode.
Setting names to be displayed in memory
recall buttons
Notes
The name you set using the following procedure is
displayed only when "Menu Shortcut" or "Utility
Command" has been assigned to the selected memory
Lit orange
When the function is
assigned
When the function is
assigned
When the function is
assigned
Off
Off
Off
Off
Off
Off
Disabled
When the function is
assigned
When the function is
assigned
Disabled