Parallel Output Settings (Output Config Menu); Assigning A Gpi Output Port - Sony MVS-8000X User Manual

selection made in step 2 when the input is low, press
[L Set].
This confirms the setting, which appears in the status
area.
To Set the Level for the Format Converter
1
Set "System Format" for "Action" using the same
operation in Step 4 of "Making DCU GPI Input
Settings" (page 555).
The format converter list appears.
2
Select the format converter that you want to set from
the list.
3
In the <FC Input/Output> group, press [H Set] or [L
Set] to set the high level or low level, respectively.
Parallel Output Settings
(Output Config Menu)
For the DCU parallel output ports, after carrying out tally
settings in the Router/Tally >Tally Enable menu, you can
assign GPI outputs to output ports that are still unused.
To assign DCU outputs to DCU parallel output ports,
display the DCU >Output Config menu.
To display the Output Config menu
In the Engineering Setup menu, select VF5 'DCU' and
HF3 'Output Config.'
The status area shows output port information.

Assigning a GPI Output Port

1
In the DCU >Output Config menu, select what the
setting applies to (DCU1 or DCU2) from the <DCU
Select> group.
2
In the <Parallel Output Assign> group, press [GPI
Output].
3
Using any of the following methods, select the output
port and GPI output number.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
Knob Parameter Adjustment
1 Parallel Output port slot
Output Slot
2 Parallel Output port
Output
Port
5 GPI Output GPI output
a) When the MKS-2700 is connected, select 2.
b) When the MKS-2700 is connected, select a value in the range 1 to 36.
4
To confirm the selected setting, press [GPI Output
Set].
This confirms the selection, which is reflected in the
status area.

Parallel Output Settings (Output Config Menu)

Setting values
a)
2 to 6
b)
1 to 54
1 to 50
557