Configuring An Interface To Check The Calling Number When An Incoming Call Comes; Configuring Progress-To-Alerting Conversion; Configuring Isdn To Carry The Calling-Name Field In Outgoing Packets - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Step
Clear ISDN statistics.
7.
Configuring an interface to check the calling
number when an incoming call comes
Step
Enter system view.
1.
Enter interface view.
2.
Configure the interface to
3.
check the calling number
when an incoming call
comes.

Configuring progress-to-alerting conversion

When ISDN is processing voice calls, Alerting messages are used as ring indications as defined in
the standard protocol. However, some devices use Progress messages as ring indications. In this
case, convert the received Progress messages into Alerting messages. You can use the related
command to determine whether to perform the conversion. The conversion is needed when the
current device is connected to a device using Progress messages as ring indications. Otherwise, the
conversion is unnecessary. The conversion is enabled by default.
To configure Progress-to-Alerting conversion:
Step
Enter system view.
1.
Enter interface view.
2.
Configure the ISDN interface
3.
to convert received Progress
messages into Alerting
messages.
Configuring ISDN to carry the Calling-Name field
in outgoing packets
Step
Enter system view.
1.
Enter interface view.
2.
Command
isdn statistics clear
Command
system-view
interface interface-type
interface-number
isdn caller-number
caller-number
Command
system-view
interface interface-type
interface-number
isdn message-conversion
progress-to-alerting enable
Command
system-view
interface interface-type
interface-number
71
Remarks
Optional.
Remarks
N/A
N/A
Execute this command to
configure limited incoming calls.
Remarks
N/A
N/A
Optional.
Enabled by default.
Remarks
N/A
N/A