Finding Feature Information - Cisco Catalyst 2960 series Configuration Manual

Information About Writing EEM Policies Using
the Cisco IOS CLI
•
•
•
•
•
•
•

Finding Feature Information

Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Prerequisites for Writing EEM Policies Using the Cisco IOS CLI
• Before writing EEM policies, you should be familiar with the concepts explained in the "Embedded
• If the action cns-event command is used, access to a Cisco Networking Services (CNS) Event gateway
• If the action force-switchover command is used, a secondary processor must be configured on the
Finding Feature Information, page 1683
Prerequisites for Writing EEM Policies Using the Cisco IOS CLI, page 1683
Information About Writing EEM Policies Using the Cisco IOS CLI, page 1684
How to Write EEM Policies Using the Cisco IOS CLI, page 1696
Configuration Examples for Writing Embedded Event Manager Policies Using Tcl, page 1744
Additional References, page 1759
Feature Information for Writing EEM 4.0 Policies Using the Cisco IOS CLI, page 1760
Bug Search Tool
Event Manager Overview" module.
must be configured.
device.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
C H A P T E R
and the release notes for your platform and software release. To
71
1683