Clearing Interface Counters - Dell PowerEdge M IO Aggregator Command Reference Manual

Clearing Interface Counters

The counters in the
not clear the counters captured by any SNMP program.
To clear the counters, use the following command in EXEC Privilege mode:
Command Syntax
clear counters [interface]
When you enter this command, you must confirm that you want FTOS to clear the interface counters for
that interface (Figure
Figure 10-24. Clearing an Interface
FTOS#clear counters tengig 0/0
Clear counters on TenGigabitEthernet 0/0 [confirm]
FTOS#
command are reset by the
show interfaces
Command Mode
EXEC Privilege
10-24).
clear counters
Purpose
Clear the counters used in the
VRRP groups, VLANs, and physical interfaces or selected ones.
Without an interface specified, the command clears all interface
counters.
• (OPTIONAL) Enter the following interface keywords and slot/
port or number information:
For a Loopback interface, enter the keyword loopback followed
•
by a number from 0 to 16383.
For a Port Channel interface, enter the keyword port-channel
•
followed by a number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port numbers.
TenGigabitEthernet
• For a VLAN, enter the keyword
from 1 to 4094.
command. This command does
show interface commands for all
vlan followed by a number
Interfaces | 147