First Steps with the TNC 620 | Graphically testing the first part (option 20)
Starting the test run
Press the RESET + START soft key
The control resets the previously active tool data
The control simulates the active program up to a
programmed break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key
The control interrupts the test run
Press the START soft key
The control resumes the test run after a break
Further information on this topic
Performing a test run
Further information:
Graphic functions
Further information:
Adjusting the simulation speed
Further information:
page 701
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
"Test run", page 713
"Graphics (option 20)", page 700
"Speed of the setting test runs",
1
79