Install A Drive Filler Panel - Oracle SPARC T5-2 Service Manual

If you cold-serviced the drive, restore power to the server. Complete the
■
procedure described in
or "Power On the Server (Power Button)" on page
■
If you hot-serviced the drive, configure it using the cfgadm -c configure
command. The following example shows the drive at c0::dsk/c1t1d0 being
configured.
# cfgadm -c configure c0::dsk/c1t1d0
Replace c0:dsk/c1t1d0 with the drive name that applies to your situation.
6. Verify the drive functionality.
See "Verify Drive Functionality" on page
Related Information
"Locate a Faulty Drive" on page 71
■
"Remove a Drive" on page 71
■
"Remove a Drive Filler Panel" on page 74
■
"Install a Drive Filler Panel" on page 77
■
"Verify Drive Functionality" on page 78
■

Install a Drive Filler Panel

Remove a drive or a drive filler panel.
1.
See "Remove a Drive" on page 71
2. Fully open the release lever on the drive filler panel.
"Power On the Server (Oracle ILOM)" on page 172
78.
or "Remove a Drive Filler Panel" on page
Install a Drive Filler Panel
173.
74.
Servicing Drives 77