Install A Drive Filler - Oracle SPARC T7-2 Service Manual

Install a Drive Filler

# hotplug enable /SYS/DBP/NVME0
Check that the drive's state has changed to ENABLED.
# hotplug list –lc
5. Verify the drive functionality.
See "Verify a Drive" on page
Related Information
"Determine Which Drive Is Faulty" on page 67
■
"Remove a Drive" on page 67
■
"Remove a Drive Filler" on page 71
■
"Install a Drive Filler" on page 74
■
"Verify a Drive" on page 75
■
Install a Drive Filler
Fully open the release lever on the drive filler.
1.
2. Install the drive by completing the following tasks.
74 SPARC T7-2 Server Service Manual • July 2019
75.