Verify Power Supply Functionality - Oracle SPARC T5-2 Service Manual

Verify Power Supply Functionality

1. Verify that the amber Service Required LED on the replaced power supply is not
lit.
Verify that the PS Fault LED on the front of the server is not lit.
2.
3.
Use the Oracle ILOM show faulty command to verify that the fault has been
cleared.
See "Check for Faults" on page 46
Perform one of the following tasks based on your verification results:
4.
If the previous steps did not clear the fault, see
■
for information about the tools and methods you can use to diagnose component faults.
If the previous steps indicate that no faults have been detected, then the component has been
■
replaced successfully. No further action is required.
Related Information
"Locate a Faulty Power Supply" on page 91
■
"Front Panel Components (Service)" on page 13
■
"Rear Panel Components (Service)" on page 15
■
for more information on using the show faulty command.
"Detecting and Managing Faults" on page 31
Verify Power Supply Functionality
Servicing Power Supplies 95