Oracle SPARC T5-2 Service Manual page 134

Verify SP Functionality
Note that the LED will flash green while the SP initializes the Oracle ILOM firmware. See
"Interpreting LEDs" on page 36
2.
Use the Oracle ILOM show faulty command to verify that the fault has been
cleared.
See "Check for Faults" on page 46
Perform one of the following tasks based on your verification results:
3.
If the previous steps did not clear the fault, see
■
for information about the tools and methods you can use to diagnose component faults.
If the previous steps indicate that no faults have been detected, then the component has been
■
replaced successfully. No further action is required.
Related Information
Oracle ILOM documentation
■
"Install the SP" on page 131
■
134 SPARC T5-2 Server Service Manual • February 2017
for information about the status of the SP LED.
for more information on using the show faulty command.
"Detecting and Managing Faults" on page 31