Oracle SPARC T5-2 Service Manual page 154

Reactivate RAID Volumes
6. List all connected logical RAID volumes to determine which volumes are in an
inactive state.
ok show-volumes
For example, the following output shows an inactive volume:
ok show-volumes
Volume 0 Target 389 Type RAID1 (Mirroring)
WWID 03b2999bca4dc677
Optimal Enabled Inactive
2 Members
Disk 1
Primary Optimal
Target 9
Disk 0
Secondary Optimal
Target c
7. For each RAID volume listed as inactive, type the following command to activate
that volume.
ok inactive_volume activate-volume
where inactive_volume is the name of the RAID volume that you are activating. For example:
ok 0 activate-volume
Volume 0 is now activated
Note -
Administration.
8. Unselect the SCSI device.
ok unselect-dev
Confirm that you reactivated the volume.
9.
ok probe-scsi-all
/pci@400/pci@2/pci@0/pci@e/scsi@0
FCode Version 1.00.54, MPT Version 2.00, Firmware Version 5.00.17.00
Target a
Unit 0
SATA device PhyNum 3
Target b
GB Unit 0
154 SPARC T5-2 Server Service Manual • February 2017
HITACHI H103030SCSUN300G A2A8
HITACHI H103030SCSUN300G A2A8
For more information on configuring hardware RAID on the server, refer to Servers
Removable Read Only device
Disk SEAGATE ST914603SSUN146G 0868
583983104 Blocks, 298 GB
TEAC DV-W28SS-R 1.0C
286739329 Blocks, 146