Oracle SPARC T5-2 Service Manual page 124

Remove a PCIe Card or Filler Panel
A customer can perform this procedure. The server must be completely powered down
before performing this procedure. See
information about cold-service procedures.
1. Prepare for servicing.
Attach an antistatic wrist strap.
a.
b. Power off the server and disconnect all power cords from the server power
supplies.
See
c. Extend the server to the maintenance position.
See
d. Remove the top cover.
See
Locate the PCIe card or filler panel that you want to remove.
2.
See "Rear Panel Components (Service)" on page 15
locations.
If you are removing a PCIe card slot filler panel, go to
3. If necessary, make a note of the slot location for each PCIe card you plan to
remove.
4. Unplug all data cables from the PCIe card.
Note the location of all cables for reinstallation later.
Remove any transceivers from the PCIe card before removing the card.
5.
Remove the PCIe card by completing the following tasks.
6.
See these figures if you are removing a PCIe card.
■
124 SPARC T5-2 Server Service Manual • February 2017
"Removing Power From the Server" on page
"Extend the Server to the Service Position" on page
"Remove the Top Cover" on page
"Component Service Categories" on page 57
58.
63.
67.
for information about PCIe slots and their
Step 6.
for more