Run Post With Maximum Testing - Oracle SPARC T5-2 Service Manual

cd
set
show
->
Related Information
"POST Overview" on page 41
■
"Oracle ILOM Properties That Affect POST Behavior" on page 41
■
"Run POST With Maximum Testing" on page 45
■

Run POST With Maximum Testing

This procedure describes how to configure the server to run the maximum level of POST.
1. Log in to Oracle ILOM.
See "Log In to Oracle ILOM (Service)" on page
2.
Set the virtual keyswitch to diag so that POST runs in service mode.
-> set /HOST keyswitch_state=diag
Set keyswitch_state to Diag
3. Reset the server so that POST runs.
There are several ways to initiate a reset. This example shows a reset using the reset
command.
-> reset /SYS
Are you sure you want to reset /SYS (y/n)? y
Resetting /SYS
Related Information
"POST Overview" on page 41
■
"Oracle ILOM Properties That Affect POST Behavior" on page 41
■
"Configure POST" on page 43
■
Run POST With Maximum Testing
35.
Detecting and Managing Faults 45