Install A Drive Or Drive Filler - Oracle SPARC T8-1 Service Manual

Hide thumbs Also See for SPARC T8-1:
Table of Contents

Advertisement

"Verify a Drive" on page 66

Install a Drive or Drive Filler

Installing a drive into a server is a two-step process. You must first install the drive into the
drive slot and then configure that drive to the server.
If you removed an existing drive from a slot in the server, you must install the
Note -
replacement drive in the same slot as the drive that was removed. Drives are physically
addressed according to the slot in which they are installed.
Unpack the drive and place it on an antistatic mat.
1.
Fully open the release lever on the drive.
2.
3.
Install the drive or drive filler by completing the following tasks.
a.
Slide the drive or drive filler into the drive slot until it is fully seated.
b.
Close the latch to lock the drive or drive filler in place.
Install a Drive or Drive Filler
Servicing Drives
65

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPARC T8-1 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents