Oracle SPARC T5-2 Service Manual page 92

Remove a Power Supply
See
Do not allow the CMA to hang unsupported while it is unattached.
2. Disconnect the power cord from the power supply that displays an amber lit
Service Action Required LED.
3. Press down on the release latch to open the ejector arm.
4. Slide the power supply out of the chassis.
Caution -
completely out of the chassis. Use care when removing the power supply to prevent it from
falling.
Caution -
supply. Otherwise, the server might overheat due to improper airflow. If a new power supply is
not available, leave the failed power supply installed until it can be replaced.
92 SPARC T5-2 Server Service Manual • February 2017
"Release the CMA" on page
There is no "catch" mechanism on the power supply to prevent it from sliding
Whenever you remove a power supply, you should replace it with another power
64.