Oracle SPARC T5-2 Service Manual page 111

g.
Switch to the system console and type the Oracle Solaris fmadm faulty
command.
# fmadm faulty
If any faults are reported, refer to the diagnostics instructions described in
Faults" on page
5. Switch to the Oracle ILOM command shell.
6.
Run the show faulty command.
-> show faulty
Target | Property
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0 | fru
/SP/faultmgmt/0 | timestamp
/SP/faultmgmt/0/ | sunw-msg-id
faults/0 |
/SP/faultmgmt/0/ | uuid
faults/0 |
/SP/faultmgmt/0/ | timestamp
faults/0 |
If the show faulty command reports a fault with a UUID go to
report a fault with a UUID, you are done with the verification process.
7.
Switch to the system console and type the fmadm repair command with the UUID.
Use the same UUID that was displayed from the output of the Oracle ILOM show faulty
command.
# fmadm repair 3aa7c854-9667-e176-efe5-e487e520
46.
| Value
| /SYS/MB/CMP0/MR1/BOB1/CH0/D0
| Dec 14 22:43:59
| SUN4V-8000-DX
|
| 3aa7c854-9667-e176-efe5-e487e520
| 7a8a
| Dec 14 22:43:59
|
Enable and Verify Newly Installed DIMMs
"Check for
Step 7. If show faulty does not
Servicing Memory Risers and DIMMs 111