Tool Availability - Oracle SPARC T5-2 Service Manual

Understanding Diagnostics
Step Diagnostic Action
1. Confirm that the Power OK
and AC OK LEDs are lit.
2. Check the server for detected
faults.
3. Check the log files for fault
information.
4. Run Oracle VTS software.
Related Information
"Tool Availability" on page 34
■
"Log In to Oracle ILOM (Service)" on page 35
■
"Oracle ILOM Service-Related Tools" on page 35
■

Tool Availability

This table describes what tools are available at the different states in which the server operates.
Tool
Status LEDs
PSH commands
Oracle ILOM logs and commands
OpenBoot commands
Oracle Solaris logs and commands
Oracle VTS
Third-party software
34 SPARC T5-2 Server Service Manual • February 2017
Possible Outcome
If these LEDs are not lit, check the power source and
power connections to the server.
Use these tools to check for faults:
■ System LEDs on the front and rear panels.
■ fmadm faulty from the Oracle Solaris prompt or
through the Oracle ILOM fault management shell.
■ show faulty from the Oracle ILOM. prompt or
through the Open Problems BUI
■ Datacenter management tools, such as Oracle
Enterprise Manager Ops Center.
If system messages indicate a faulty component, replace
it.
To run Oracle VTS, the server must be running the
Oracle Solaris OS.
■ If Oracle VTS reports a faulty component, replace it.
■ If Oracle VTS does not report a faulty component,
run POST.
Standby Power
Yes
Yes
Yes
No
No
No
No
Links
"Interpreting LEDs" on page 36
"Check for Faults" on page 46
"Interpreting Log Files and System
Messages" on page 50
■ Refer to the Oracle VTS software
documentation.
■ "Configuring
POST" on page 40
■ Contact technical support if the
problem persists.
OpenBoot Prompt Oracle Solaris
Prompt
Yes Yes
No Yes
No No
Yes No
No Yes
No Yes (if installed)
No Yes (if installed)