Table of Contents
Advertisement
For more detailed instructions for making this change, see
the following section of the user's guide:
Emulation Mode (Keypad)
Part III Section K.l
Group 1 Options 1, 2, and 3
You may also make this change through a software com-
mand. The instructions for using this method are located
in the following place in this user's guide:
Part IV Section F
Emulation Mode (Software)
Be sure to make any necessary changes to your software
setup so it matches the emulation you have chosen. You
will find this information in the instructions for your soft-
ware package. It is usually listed under "Printer Configu-
ration" or a similar heading.
G.4
Selecting Emulation Features
Once an emulation mode has been selected, the default
features of that emulation are in effect. These features can
be changed to meet your requirements. (See Appendices
D-H
of this user's guide for a detailed description of the
features and commands of each emulation.)
For instructions for making these changes, see the follow-
ing sections of the user's guide:
ANSI Command Mode Features
Part III Section B
Group A Options 1 to 9
Tutorial
2-23
Advertisement
Table of Contents
