Table of Contents
Advertisement
matches the current page orientation. Use the Orientation
command to switch from portrait to landscape fonts.
To ensure that the correct font is selected, it is recom-
mended
to
specify all font parameters, rather than depend-
ing on the fuzzy font selection process. For example, the
command sequence
<ESC>&IOO<ESC >(8U <ESC >(sOP<ESC>(slOH
<ESC>(s12V <ESC>sOS<ESC>(sOB<ESC>(s3T
will select the resident Courier portrait font. This can be
compressed into
<ESC>&IOO<ESC>(8U <ESC>(splOh12vsb3T
While the printer is in LaserJet emulation mode you can-
not select fonts with QMS-ML, Epson, or Proprinter char-
acter sets by using the LaserJet font description escape
sequences. Fonts with these character sets may be se-
lected by using the Printer Software Command to change
fonts (see Part IV of this manual for details). The printer
disregards font selections made through the keypad during
LaserJet emulation mode.
F.2
Font Definition Commands
NOTE:In the font definition commands, the first parameter
nl defines whether the command applies to the primary or
secondary font:
Value
Applicable Font
(
Primary
)
Secondary
I
<ESC>nln21 Character Set
This group of commands selects the character set for the
HP Emulation Mode
H-25
Advertisement
Table of Contents
