Table of Contents
Advertisement
Bits 1-6 Amount of space to add/subtract
(1/120 inch increments)
Bit 7
0 (positive) or
1
(negative)
Locate this number in the Binary column of the ASCII
Conversion Table in APPENDIX B at the back of this
manual. Then, substitute the
equival~nt
Hex, Decimal, or
Octal value (as required by your system) for "n" in the
command above.
I
<ESC><BS>
I
BACKSPACE 11120"
If you send this command, the print position is moved
backward 1/120 inch.
I
<ESC>=
I
AUTO LINE CENTERING
The Auto Line Centering command is used to center ti-
tles or other lines of data. The command must be sent
first. The data which is to be centered should then be
entered and followed by a Carriage Return or a Line Feed
command. The words will be centered between the mar-
gins, or, if the line is long, they will be centered beyond
the Right and Left Margins. This command will override
Auto Justify if the Auto Justify command is on. The Auto
Line Centering command is turned off by a carriage return
or line feed.
Examples:
This input
<ESC>=Always center your titles.
generated this example:
Always center your titles.
0-26
Diablo Emulation Mode
Advertisement
Table of Contents
