Table of Contents
Advertisement
I
<ESC>E
I
Reset Printer
This command causes the printer to print the current page
(if any) and reset all programmable features to their default
values. It is useful for restoring the printer to a known
state after each job, but can also be used between pages
of the same job.
The reset command affects the following aspects of the
current environment:
Printer stays on-line
Print position set to top left margin
Parameters set to default values
Temporary macros are deleted
Temporary fonts are deleted
I
<ESC>z
I
Printer Self-Test
This command causes the printer to test its own interface
circuits. The current page is printed, and the self-test is
run without losing data or the current environment. If an
interface problem is detected, the printer is automatically
placed off-line, otherwise the printer is ready to proceed
with the next page.
HP Emulation Mode
H-63
Advertisement
Table of Contents
